Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Lumberton, MS

Broken Garage Door Spring Repair in Lumberton, MS

Fast replacement of broken torsion or extension springs, sized to your door's weight. Typical cost $200-$450.

Our broken garage door spring repair service in Lumberton, MS comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Fast replacement of broken torsion or extension springs, sized to your door's weight.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for broken garage door spring repair?

  • A loud bang from the garage, like a gunshot
  • A visible gap in the coils of the spring above the door
  • The door feels extremely heavy or won't lift more than a few inches
  • The opener strains, hums or the door reverses right away
  • Cables hanging loose from the drums

What usually causes it

  • Springs reaching the end of their cycle life (usually about 10,000 cycles)
  • Rust on the coils, which adds friction and stress
  • Springs that were the wrong size for the door
  • Cold weather making worn steel more brittle

Safe checks before you call

  • Don't use the opener. It can strip gears or pull the door off track.
  • Don't try to lift the door by hand. Without a working spring it may weigh 130 to 250 pounds or more.
  • Look, but don't touch: a broken torsion spring shows a clear gap in the coils.
  • Keep the door closed and keep children and pets away from it.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Secure the door and safely unwind any remaining spring tension
  2. Weigh and measure the door to size the new springs correctly
  3. Install new springs (we recommend replacing both on a two-spring door)
  4. Wind, set and balance the door so it stays put halfway up
  5. Test the opener's force and auto-reverse settings

Typical broken garage door spring repair prices

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Local broken garage door spring repair for Lumberton, MS

Humidity in Mississippi puts a thin layer of rust on spring coils, and that friction wears springs out early. Coated or galvanized springs last noticeably longer here.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Our broken garage door spring repair service covers Lumberton (ZIP code 39455) and nearby towns including Purvis (10.1 mi), Poplarville (12.1 mi), Wiggins (21.2 mi) and West Hattiesburg (22.4 mi). Call (833) 435-8883 to book a visit in Lumberton.

Broken Garage Door Spring Repair: frequently asked questions

How much does broken garage door spring repair cost in Lumberton, MS?

Broken Garage Door Spring Repair typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do broken garage door spring repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is broken garage door spring repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Mississippi or Lumberton requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Lumberton, MS

Skylink Opener Gear & Sprocket Replacement

Skylink makes openers and a wide range of universal replacement remotes and keypads.

Typical $125-$275

Allstar Opener Gear & Sprocket Replacement

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $125-$275

Raynor Extension Spring Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $150-$350

Garaga Garage Door Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$450

Roll-Up Door Repair

Sheet roll-up doors for storage units, sheds and warehouses repaired.

Typical $150-$600

Raynor Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Hörmann Torsion Spring Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $200-$450

Commercial Overhead Door Installation

Commercial sectional, insulated and high-cycle doors and operators installed.

Typical $2,500-$12,000

Wayne Dalton Garage Door Panel Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $300-$900

LiftMaster Opener Circuit Board Replacement

LiftMaster is the professional-installer brand of The Chamberlain Group. The color of the learn button on the motor unit shows which remotes are compatible (yellow on Security+ 2.0 models; purple, red, orange or green on older ones), and most current models work with the myQ app.

Typical $175-$400

Genie Garage Door Sensor Repair

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $100-$250

Overhead Door Weather Seal Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $100-$300

Garage door stuck, noisy or broken?

Talk to a garage door technician in Lumberton, MS now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote